C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Position the NEW seal in the front case with the part number facing out.
2. Using J 44731 install the input shaft.
Notice: Refer to Fastener Notice in Service Precautions.
3. Position the clutch actuator cylinder.
4. Install the clutch actuator cylinder bolts.
^
Tighten the clutch actuator cylinder bolts to 8 Nm (71 inch lbs.).
5. Install the transmission.
6. Install the rear propeller shaft.
7. Check the transmission fluid level. Add if necessary.
8. Lower the vehicle.
Transmission Output Shaft Seal Replacement
Transmission Output Shaft Seal Replacement
^
Tools Required
-
J 6125-1B Slide Hammer
-
J 44732 Output Shaft Oil Seal Installer
-
J 23129 Universal Seal Remover
-
J 8614-01 Pinion Flange Holder
Removal Procedure