C Tahoe 2WD V8-5.3L VIN T (2001)
5. Remove the tool kit from the vehicle.
Installation Procedure
1. Install the tool kit and the retaining nut.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the jack and the bracket with the retaining nut.
Tighten the nuts to 9 N.m (80 lb in).
3. Install the nut retaining the tool stowage cover, if equipped.
Jack and Tool Stowage Replacement (Tahoe/Yukon)
Jack and Tool Stowage Replacement (Tahoe/Yukon)
Removal Procedure
1. Tilt forward the drivers side rear seat bottom.
2. Turn the wing nut counterclockwise.
3. Remove the tool kit.
4. Open the door on left rear of vehicle below speaker grille.
5. Turn the adjusting knob on jack counterclockwise.
