chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Rear Heater - Insufficient Heat In Extreme Cold|Page 12957 > < Cooling System, A/C - Aluminum Heater Cores/Radiators|Page 12952
Page 1
background image

Heater Core: All Technical Service Bulletins
Rear Heater - Insufficient Heat In Extreme Cold

File In Section: 01 - HVAC 

Bulletin No.: 01-01-38-005

Date: March, 2001

TECHNICAL

Subject:
Insufficient Heat From Rear Heater During Extreme Cold Weather 
(Replace Rear Heater Tee Couplings)

Models:
2000-01 Chevrolet and GMC C/K Utility Models 
(Suburban, Tahoe, Yukon, Yukon XL) Built Prior to October, 2000

Condition

Some customers may comment on insufficient heat from the rear heater during periods of extreme cold weather.

Cause

A restriction in the tee coupling located at the heater core inlet and outlet limits the coolant flow to the rear heater core.

Correction

Replace the original inlet and outlet heater tee couplings with revised couplings that have an increased inside diameter to improve coolant flow. Use the
following procedure and the part numbers listed below.

1.

Open the hood.

2.

Drain the coolant. Refer to the Engine Cooling subsection of the Service Manual.

3.

Disconnect the main heater hoses from the heater tee connectors.

4.

Remove the clamp retaining the accumulator. Reposition the accumulator as required in order to gain access to the tee clamps.

Notice:

The original quick connect fittings on the heater tees are made of a plastic that will not allow sufficient flexibility to release the connectors without
breaking them. It is advisable to crack the quick connects to aid in releasing them. The revised heater tees include replacement quick connects. Do
not use force that will pull on the heater core or damage the inlet or outlet pipes.

5.

Disconnect the rear heater hoses from the tee connectors.

6.

Disconnect the heater tees from the heater core.

7.

Install revised heater tees (tan - inlet tee; black - outlet tee) to the rear heater hoses.

8.

Install the tee connectors to the heater core.

9.

Connect the main heater hoses to the heater tees.

10.

Refill and bleed the cooling system. Refer to the Engine Cooling subsection of the Service Manual.

Parts Information

Parts are currently available from GMSPO.

Warranty Information

Rear Heater - Insufficient Heat In Extreme Cold|Page 12957 > < Cooling System, A/C - Aluminum Heater Cores/Radiators|Page 12952