C Tahoe 2WD V8-5.3L VIN T (2001)
2. Ensure J 22834 is centered on the seal during installation.
3. Install the following:
^
Install the yoke.
^
Install the rubber washer spline seal.
^
Install the washer.
^
Install the mainshaft nut.
4. Use the J 8614-01 in order to hold the transmission from rotating.
Notice: Refer to Fastener Notice in Service Precautions.
5. Tighten the main shaft nut.
^
Tighten the main shaft nut to 441 Nm (325 ft. lbs.).
6. Install the rear propeller shaft.
7. Check the transmission oil level.
8. Lower the vehicle.