C Tahoe 2WD V8-5.7L VIN R (1996)
Fig. 8 Exploded View Of Eaton Locking Differential.
3. Remove lock screw and pinion shaft,
Fig. 8, then roll differential pinions to access window by turning side gears and remove pinions.
4. Remove pinion thrust washers and thrust block, keeping all components in order for assembling.
5. Remove right side gear, disc pack and shim assembly, and guide clips.
6. Remove left cam gear and disc pack assembly along with shim and guide clips.
7. Clean and inspect all components, keeping components in order for assembling.
8. Replace components that are damaged, deformed or excessively worn.
Due to critical tolerances required for proper operation, the
differential case cannot be serviced separately. If case is defective, the entire differential assembly must be replaced. In addition, internal
clearances are such that shims, thrust block or gears should not be replaced unnecessarily, even if slight wear patterns are evident. If
shims, thrust block or side gears must be replaced, measurement and replacement procedures must be performed as outlined in order to
maintain critical assembly clearances.
Cam Gear Clutch Service
