chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8725 > < Diagram Information and Instructions|Page 8722
Page 1
background image

Antenna: Initial Inspection and Diagnostic Overview

Circuit Operation

When the Radio is turned "ON," voltage is applied from the Radio (CKT 314) to the Power Antenna Assembly's Internal Relay Coil. The relay contacts
close, and battery voltage is applied to the Power Antenna Motor. Motor terminal "B" is grounded through the UP Switch and the relay contacts. The
Motor drives the Antenna Mast up. When the Antenna is at its full height, the UP Switch opens and the Motor stops.

When the Radio or Ignition Switch is turned "OFF," voltage is removed from the Relay Coil. The relay contacts open, applying battery voltage to the
Motor. The Motor terminal "A" is now grounded. The DOWN Switch at the Antenna now has voltage applied through the relay, the voltage to the motor
has reversed polarity. It runs in the opposite direction, retracting the Antenna Mast.

At the end of the Antenna's travel, the DOWN Switch opens and breaks the current flow. Both sets of switches are now in the places shown in the
schematic, the Radio is "OFF" and the Antenna Mast is down.

The Antenna is connected to the Radio by coaxial cable.

System Diagnosis

^

Refer to the Symptom Table for the proper diagnostic procedure(s).  See: Symptom Related Diagnostic Procedures/Symptom Table  

Troubleshooting Hints

Perform before beginning System Diagnosis

^

If Power Antenna goes up or down only part way, check Antenna Mast for bent or dirty condition.
^

Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a
continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be
checked by monitoring for a voltage drop with the system operational (under load).

^

Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to "Diagnostic
Aids/General Troubleshooting Procedures,"
).  See: Diagrams/Diagnostic Aids

^

Refer to System Diagnosis.  See: System Diagnosis

Initial Inspection and Diagnostic Overview|Page 8725 > < Diagram Information and Instructions|Page 8722