Camaro V6-3.8L VIN K (1995)
Hydraulic Modulator Assembly: Service and Repair
Brake Modulator
ABS Brake Modulator/Motor Pack Assembly Components
DISASSEMBLE
1. Remove gear cover. See: Gear Cover Replacement
2. Remove motor pack. See: Brake Modulator/Motor Pack Assembly Replacement
3. Two hydraulic modulator to brake combo valve banjo bolts, separate hydraulic modulator from brake combo valve.
4. Two transfer tubes with O-rings from brake combo valve or hydraulic modulator.
5. Banjo bolt O-rings from brake combo valve and hydraulic modulator. If hydraulic modulator is to be replaced, install the three gears in the same
location on replacement hydraulic modulator. Refer to Gear Replacement. No repair of the hydraulic modulator is authorized. Replace as an
assembly. Use new transfer tube assemblies when assembling the hydraulic modulator/brake combo valve assembly. Make sure two O-rings are
properly installed on each transfer tube.
ASSEMBLE
1. Two transfer assemblies. Lubricate transfer tube assembly O-rings with clean brake fluid. Install transfer tube assemblies in ports in hydraulic
modulator and push in by hand to bottom.