Camaro V6-3.8L VIN K (1995)
Brake Master Cylinder: Service and Repair
Brake Master Cylinder Replacement (with ABS)
Brake Master Cylinder
REMOVE OR DISCONNECT
1. Brake fluid from reservoir. Discard old fluid.
2. Brake combination valve pipes. Plug brake combination valve pipes to prevent fluid loss and contamination.
3. Master cylinder nuts.
4. Master cylinder.
INSTALL OR CONNECT
1. Bench bleed master cylinder.
2. Master cylinder.
3. Master cylinder nuts. Tighten brake master cylinder nuts to 29 Nm (21 ft. lbs.).
4. Fill master cylinder reservoir.
5. Brake combination valve pipes to master cylinder one at a time.
a. Remove locally fabricated plugs.
b. Install brake pipe fitting finger tight.
c. Have assistant depress brake pedal to remove air at loose brake pipe fittings. Tighten brake combination valve pipe fittings to 32 Nm (24 ft.
lbs.).
7. Have assistant quickly release and pump brake pedal several times.
8. If brake pedal remains high and firm, start vehicle. If brake pedal still feels firm, test drive vehicle. If brake pedal feels soft or spongy, bleed entire
brake hydraulic system.
