Camaro V6-3.8L VIN K (1995)
Engine Control Module: Service and Repair
Powertrain Control Module (PCM) Programming
EEPROM PROGRAMMING
1. Set-up - Ensure that the following conditions have been met:
^
The battery is fully charged.
^
The ignition is "ON."
^
The Vehicle Interface Module cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user's instructions.
3. If the PCM fails to program, proceed as follows:
^
Ensure that all PCM connections are OK.
^
Check the Techline equipment for the latest software version.
^
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be
programmed.
FUNCTIONAL CHECK
1. Perform On-Board Diagnostic System Check. See: Computers and Control Systems/Testing and Inspection
2. Start engine and run for one minute.
3. Scan for DTCs using the scan tool.
4. If DTC P0325 sets, the KS module is not fully seated, is missing, or is faulty.
