Camaro V6-3.8L VIN K (1995)
Locking Sector Gear
REMOVE OR DISCONNECT
1. Raise window about halfway.
2. Front side door trim assembly.
3. Front side door water deflector as needed.
CAUTION: Support front side door window. If window drops into door, personal injury or window damage may result
4. Support window in position by inserting rubber wedge door stops at front and rear of window between window and door inner panel.
5. Front side door window rear guide channel nuts so rear guide channel assembly can be moved.
6. Rivets (23).
^
Push rivet mandrel out of rivet (23) with a punch.
^
Drill Out rivet (23).
^
Remove rivet fragments from hole.
7. Electrical connector from motor assembly (83) by sliding motor assembly (83) and regulator assembly (82) rearward, if equipped.
8. Regulator assembly (20 or 82) from channel assemblies.
9. Regulator assembly (20 or 82), with motor assembly (83) attached if equipped, through rear access hole.
INSTALL OR CONNECT
1. Regulator assembly (20 or 82), with motor assembly (83) attached if equipped, through rear access hole.
2. Regulator assembly (20 or 82) to channel assemblies.
3. Electrical connector to motor assembly (83), if equipped.
4. Rivets (23) in sequence.
5. Front side door window rear guide channel nuts.
INSPECT
^
Window alignment. Adjust if necessary.
6. Front side door water deflector.
7. Front side door trim assembly.
Front Side Door Window Regulator Handle Assembly
Front Side Door Window Regulator Handle Assembly (Typical)
REMOVE OR DISCONNECT
