Camaro V8-305 5.0L VIN E (1992)
Impact Sensor: Service and Repair
Arming Sensor
Fig. 308 Arming Sensor Removal
1.
Deactivate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG DEACTIVATION.
2.
Remove knee bolster, refer to KNEE BOLSTER.
3.
Remove upper console.
4.
Remove arming sensor retaining bolts, then disconnect arming sensor electrical connector and remove arming sensor, Fig. 308.
5.
Reverse procedure to install, noting the following:
a. Install arming sensor with arrow pointing toward front of vehicle. Torque retaining bolts to 25 inch lbs.
b. Following installation, activate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG ACTIVATION.
c. Turn ignition switch to the On position and verify the ``Inflatable Restraint'' indicator flashes 7 to 9 times then turns Off. If indicator does not
respond, refer to DIAGNOSTIC AND TESTING PROCEDURES/TESTING PROCEDURES/RETRIEVING TROUBLE CODES.
