Camaro V8-305 5.0L VIN E TBI (1989)
1.
Refer to Figure 3. Locate bosses at the rear outboard sides of number one bow. Use a small air body saw or 90 degree grinder to remove the
bosses. Cut flush to the number one bow surface.
2.
File any burrs or rough areas. Use black exterior touch-up paint P/N 1050335 on the cut/ground areas. Follow paint instructions for drying time.
3.
Install garnish molding.
4.
Raise and latch the top.
LABOR OPERATION:
T1869
TIME ALLOWANCE:
1.3 HRS. Total Time
NOISE RELATED (II)
Application:
1989-1991
Condition:
Squeak at header inner trim garnish molding.
Correction:
Add 546 mm (21.5") of 3M # 5430 Squeak Reduction tape to garnish molding.
