Camaro V8-305 5.0L VIN E TBI (1989)
4.
Carefully shift header garnish molding rearward and out of the latch plate. Then slide header garnish molding up and out of the "A" pillar inner
garnish molding.
5.
Note Figure 4, View B. Apply 546 mm (21.5") of 3M # 5430 tape to header garnish molding inner face between the latch plate locations.
6.
Trim any tape protruding from the molding flange. Re-install the header inner trim garnish molding.
7.
Install and tighten "A" pillar inner garnish molding screws. Carefully shift edges of header garnish molding forward and between edges of the latch
plates while slipping upper lip to outside of header edge. Install and tighten header garnish screw.
IMPORTANT:
The sunshade should be mounted so that the larger pivot hole is nearest to the front of the vehicle when the sunshade is attached. Check the fit for the
sunshade. The screws should fit in evenly with no difficulty.
8.
Install sunshade aligning mounting holes, installing screws and tightening.
LABOR OPERATION:
T1871
TIME ALLOWANCE:
0.6 HR.
NOISE RELATED (III)
Application:
1992
Condition:
Number three bow snaps past number four bow when top is lowered and stowed.
Correction:
