Camaro V8-305 5.0L VIN E TBI (1989)
5.
Refer to Figure 10.
NOTE:
Tonneau seal should directly align with the trough welt to prevent water leaks. Center seal over welt.
6.
Forward tabs of tonneau seal should align just past the edge of the tonneau panel.
7.
Remove release liner from tape and loosely align new tonneau seal to the tonneau panel.
8.
Close tonneau panel slowly and observe contact of seal so that it is over the center of the welt as shown in Figure 10.
9.
Roll wall paper seam roller or equivalent over seal to bond it to the tonneau panel.
10.
Lower and latch tonneau. Lower and latch number five bow.
11.
Water test for proper sealing.
LABOR OPERATION:
