Camaro V8-305 5.0L VIN E TBI (1989)
Window Regulator And Motor
WARNING: If electric motor removal from the regulator is required, the sector gear must be locked in position. The regulator lift arm is
under tension from the counterbalance spring and could cause personal injury if the sector gear is not locked in position.
REMOVE OR DISCONNECT
1. Window regulator and motor.
^
Drill a hole through the window regulator sector gear and backplate.
^
Install a bolt and a nut to lock the sector gear into position.
2. Rivets holding window regulator motor (107) to window regulator (85) using a 3/16-inch drill bit and a drill.
3. Window regulator motor (107) from the window regulator (85) through rear access panel.
INSTALL OR CONNECT
Tool Required:J-34940 Heavy Duty Rivet Gun.
1. Window regulator motor (107) to the window regulator (85) using J-34940 and 3/16-inch nuts and bolts.
^
Remove the bolt and nut used to secure the sector gear into position during the removal procedure.
2. Window regulator and motor.
