chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Power Steering Cooler Line - Leak|Page 843 > < P/S - Rack & Pinion O-Ring Seal Fitting Leaks
Page 1
background image

Power Steering Line/Hose: All Technical Service Bulletins
Power Steering Cooler Line - Leak

Number:

84-220

Section:

3B (IX)

Date:

Nov., 1984

Subject:

P/S COOLER LINE LEAK

Model and Year:

1983-84 CAMARO Z28 WITH 5.0L (L69) ENGINE

TO:

ALL CHEVROLET DEALERS

Some 1983-84 Camaros equipped with the 5.0L V8 engine (L69) may exhibit a power steering oil cooler line leak where the short rubber hose is
clamped to the pipe at the steering gear end. The leak normally occurs when starting a cold engine at temperatures below 0~F.

FIGURE 1 - Pipe Assembly

Vehicles that experience a leak at the short hose area (see Figure 1) may be repaired by installing a new pipe assembly, P/N 14089439.
1.

Disconnect negative battery cable.

2.

Disconnect left hand air cleaner inlet duct from radiator support.

3.

Slide steering coupling shield up steering shaft for access to cooler pipe fitting.

4.

Remove cooler pipe fitting from steering gear.

5.

Remove P/S pump hose from the outlet end of the cooler pipe.

6.

Raise vehicle on hoist.

7.

Remove two (2) screws that retain cooler pipe to lower radiator support. Then remove cooler pipe.

8.

Lower vehicle.

Power Steering Cooler Line - Leak|Page 843 > < P/S - Rack & Pinion O-Ring Seal Fitting Leaks