Camaro V8-350 5.7L (1989)
(For 1989 Vehicles)
brackets and screws for
No. 1 bow and instructions)
W-27X0-8502-AXXX
Kit -
(Contains 2 latch handles
1 Kit
(ASC Part #.)
with 4 screws and
(For 1990 Vehicles)
instructions)
Following is information which the dealer will be required to provide during the telephone or fax order:
1)
Dealer Name.
2)
Dealer Code.
3)
Part Shipping Address.
4)
Contact Person.
5)
Telephone Number.
6)
Vehicle VIN.
7)
Vehicle Status:
A.
Dealer Inventory.
B.
Sold But Not Delivered.
C.
Customer Vehicle.
D.
Customer Vehicle Down For Roof Latch Problem.
The freight charge will be borne by ASC Inc. and shipped via UPS (United Parcel Service).
Service Procedure
Figure A
THE FOLLOWING INFORMATION OUTLINES AND ILLUSTRATES THE PROCEDURE WHICH MUST BE USED TO CORRECTLY
REPLACE THE CONVERTIBLE TOP LATCH HANDLE ASSEMBLIES. RETAINING BRACKETS (INCLUDED IN THE 1989 KIT
V-27X0-8502-AXXX) FOR THE NO. 1 BOW GARNISH MOLDING WILL BE INSTALLED ON SOME 1989 VEHICLES AS PART OF THE
PROCEDURE.
1.
Inspect both sides for previously installed modified latch handles (Figure A - correct latch handles will have stainless steel pins with flats). If
vehicle has modified latch handles, install Campaign Identification Label and return vehicle to customer. If vehicle does not have modified
latch handles proceed with steps 2 through 25.
2.
Lower side windows.
3.
Pull release lever on left side of tonneau cover forward to release rear bow.
4.
Raise rear bow to full vertical position.
5.
Push tonneau cover release switch, located on console, rearward to release tonneau cover.
6.
Assure tonneau cover raises to full vertical position.
7.
Lower rear bow to original position.
