chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

All Other Service Bulletins for Brake Caliper: > < Brakes - Rear Disc Moan|Page 3908
Page 3
background image

Figure 4 - Park Brake Adjustment

14.

Adjust the park brake cable at the equalizer until both of the P/B levers just start to move off the caliper stops (See Figure # 4).

15.

Readjust the P/B cable until both levers just touch the stops.

16.

Lower the vehicle and cycle the P/B lever three (3) times.

17.

Raise the vehicle and recheck to insure the P/B levers are still just touching the stops Readjust if necessary.

IMPORTANT:

If the P/B cable is not properly adjusted the brakes might still moan. Make sure this procedure is properly completed.

18.

Install the wheel, and tires.

19.

Check that the wheels spin freely in both directions.

20.

Install the prop shaft at the axle in the original position. Torque bolts to 22 N.-m (16 ft. lbs.).

21.

Check rear axle fluid and fill as required.

22.

Lower the vehicle.

PARTS REQUIRED PER VEHICLE

Part Number

Description

Quantity

10136851

Left Plate

1 Required

10136852

Right Plate

1 Required

10132836

Brake Pads

1 Required

10033619

Nuts - Torque

8 Required

Prev.

Parts are expected to be available on May 12, 1989. Until then normal part orders will not be accepted by GMSPO. Only verifiable emergency VIP
orders will be accepted. SPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the part
will be shipped premium transportation at dealer's expense. All other order types will be canceled as incorrectly ordered while the 400 control is in place.

Labor Operation Number:

T1439

Labor Time:

1.5 Hours

All Other Service Bulletins for Brake Caliper: > < Brakes - Rear Disc Moan|Page 3908