Camaro V8-350 5.7L (1989)
6.
Attach electrical cable to clamp and mount. If a bind condition is noted after mounting cable, remove cable from clamp and allow to move freely.
7.
Check operation of solenoid with quarter trim panel in position, before attaching panel with fasteners.
8.
If needed, re-position cable elsewhere to assist smooth operation. Repeat above steps as necessary.
9.
Reinstall the quarter trim panel.
LABOR OPERATION:
T1870
TIME ALLOWANCE:
1.3 HRS. Both Sides
OPERATING ISSUES (II)
Application:
1987-1992
Condition:
Tonneau panel and quarter cap belt molding protector decal (marnot tape) yellowing.
Correction:
Replace decals with Tonneau Protector Decal P/N 12520107 and Quarter Belt Cap Belt Molding Decal P/N 12520108-9 right and left.
1.
For replacement of Tonneau Protector Decal refer to the 1992 Camaro Service Manual Section 10-8-19.
2.
For replacement of Quarter Cap Belt Molding Decal refer to the 1992 Camaro Service Manual Section 10-6-7.
LABOR OPERATION:
B3700 Tonneau, Applique Storage Lid
TIME ALLOWANCE:
0.6 HR.
LABOR OPERATION:
B8235 Protector Rear Quarter Cap Mldg., Right-Hand
TIME ALLOWANCE:
0.5 HR.
LABOR OPERATION:
B8236 Protector Rear Quarter Cap Mldg., Left-Hand
TIME ALLOWANCE:
0.5 HR.
OPERATING ISSUES (III)
Application:
1987-1992
Condition:
Number five bow release housing slide mechanism broken. 1992 VIN 189526.
Correction:
Replace bezel housing assembly and cable assembly with kit P/N 12517351.
1.
Release and raise number five bow to its vertical position.
2.
Release and raise tonneau to its vertical position.
