Camaro V8-350 5.7L (1989)
5. Rivets, using a 1/4-inch drill bit and drill.
^
Move window regulator and window regulator motor rearward.
6. Wire connector from window regulator motor.
7. Roller on the regulator lift arm from the regulator cam.
8. Window regulator and motor through rear access hole.
INSTALL OR CONNECT
Tool Required:
J-34940 Heavy Duty Rivet Gun
1. Window regulator and window regulator motor through rear access hole.
2. Lift arm roller into the regulator cam.
3. Wire connector to window regulator motor.
4. Regulator to inner panel using J-34940 and 1/4- inch peel-type rivet.
^
If J-34940 is not available, use the following nut and bolt method.
^
Install U-clips on the window regulator at attaching locations. Be sure to install the clips with clinch nuts on the outboard side of the window
regulator.
^
Fit the lift arm roller into the regulator cam.
^
Align the window regulator with the clinch nuts to the holes in the inner door panel.
^
Attach the window regulator to the door inner panel using M6.0 x 1 x 13 (1/4-20 x 1/2-inch) bolts into 6 mm (1/4-inch) nuts with integral
washers. Tighten bolts to 12 Nm (106 lb. in.).
5. Inner panel cam.
6. Window guide cam.
INSPECT
^
Window regulator operation.
^
Window glass adjustments and make adjustments as needed.
7. Water deflector.
Window Regulator Motor
Window Regulator And Motor
WARNING: If electric motor removal from the regulator is required, the sector gear must be locked in position. The regulator lift arm is
under tension from the counterbalance spring and could cause personal injury if the sector gear is not locked in position.
REMOVE OR DISCONNECT
1. Window regulator and motor.
^
Drill a hole through the window regulator sector gear and backplate.
^
Install a bolt and a nut to lock the sector gear into position.
2. Rivets holding window regulator motor (107) to window regulator (85) using a 3/16-inch drill bit and a drill.
3. Window regulator motor (107) from the window regulator (85) through rear access panel.
INSTALL OR CONNECT
Tool Required:J-34940 Heavy Duty Rivet Gun.
1. Window regulator motor (107) to the window regulator (85) using J-34940 and 3/16-inch nuts and bolts.
^
Remove the bolt and nut used to secure the sector gear into position during the removal procedure.
2. Window regulator and motor.
Window Glass Adjustments
