Camaro V8-5.7L VIN G (1998)
Shock Sensor: Service and Repair
REMOVAL PROCEDURE
1. Remove the right quarter inner rear trim finishing panel.
2. Disconnect the shock sensor electrical connector (2).
3. On the convertible, remove the shock sensor (1) from the wheelhouse bracket.
4. Disconnect the shock sensor electrical connector (2).
5. On the coupe, remove the shock sensor (1) from the right rear inner wheelhouse.
6. Remove the shock sensor (2) from the vehicle.
7. Clean the shock sensor mounting surface.
INSTALLATION PROCEDURE
IMPORTANT: The shock sensor sensitivity is preset and should not require adjustment. Remove the label covering and adjust only if more or less