Camaro V8-5.7L VIN G (1998)
Cause
The small water deflectors may be mispositioned or improperly installed.
1.
Make sure the rectangular slot is taped over with duct tape. Refer to item 1 in Figure 2.
2.
Ensure the water deflector seals fully to the door inner panel surface. It may be necessary to make two small 76 mm x 76 mm (3 in x 3 in) water
deflectors. Refer to item 2 in Figure 2 and install these to the inside of the door inner panel at the locations indicated. Use a piece of plastic from
the shipping protective material for either the door trim panel or the seat assemblies (or similar material).
Condition
The front or rear floor is wet (convertible, hard top, T-top models).
Cause
The water deflector may not ne seated properly to the door surface.
Correction
Seat the water deflector to the door surface at the primary locations. Refer to Figure 3. If the adhesive surface is dirty and the water deflector needs to be
replaced, follow the service procedure listed below.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
