Camaro V8-5.7L VIN G (1998)
1.
The hood release cable may not be sealed at the front of dash. Refer to item 1 in Figure 5.
2.
The body harness grommet may not be sealed. Refer to item 2 in Figure 5.
Correction
Make sure both are SEATED properly. if necessary. seal with GM Weatherstrip Adhesive, P/N 12345097 (in Canada, use P/N 10953479).
Condition
The molded weatherstrip detail at the base of the windshield may not be properly sealed causing the front floor to be wet (hard top, T-top models).
Cause
The material sealing the weatherstrip detail to the body surface between the pillar retainer and the mounting flange on the hinge pillar may be
mispositioned or missing.
Correction
Apply a new seal using GM Silicone Sealant, P/N 12345739 (in Canada, use P/N 10953541), as shown in Figure 6 (almost a straight line from the outer
edge of the pillar retainer to the inner hinge pillar flange should be used) and reinstall the weatherstrip to the flange retainer.
Condition
The front roof gutter molded weatherstrip detail to the roof sheet metal may not be sealed properly (T-top models). Water entering this area usually runs
down the "A" pillar and ends up on the carpet below the instrument panel.
Cause
^
The weatherstrip molded detail may not be sealed to the sheet metal gutter.
^
Small holes or tears may exist in the molded detail at the attaching insent.
Correction
