Camaro V8-5.7L VIN G (1998)
1.
Apply a new seal using GM Silicone Sealant, P/N 12345739 (in Canada, use P/N 10953541), to the end of the roof gutter, under the molded
weatherstrip detail, as shown in Figure 7.
2.
Apply an even amount of GM P/N 12345097 (in Canada, use P/N 10953479) or 3M P/N 08011, or the equivalent, to the hole or tear for sealing.
Condition
The rear roof gutter molded weatherstrip detail to the roof sheet metal may not be sealed properly causing water leaks (T-top models).
Cause
^
The weatherstrip molded detail may not be sealed to the sheet metal gutter.
^
Small holes or tears may exist in the molded detail at the attaching insert.
1.
Apply GM Silicone Sealant, P/N 12345739 (in Canada, use P/N 10953541), to the end of the roof gutter, under the molded weatherstrip detail, as
shown in Figure 8.
2.
Apply an even amount of GM P/N 12345097 (in Canada, use P/N 10953479) or 3M P/N 08011, or the equivalent, to the hole or tear for sealing.
Condition
The molded weatherstrip detail at the base of the lock pillar may not be sealed properly causing windnoise and/or water leaks (hard top, T-top models).
Cause
The material sealing the weatherstrip detail to the body surface between the lock pillar retainer and the mounting flange on the quarter panel may be
mispositioned or missing.
Correction
