Camaro V8-5.7L VIN G (1998)
7. If equipped with ABS only, remove one wave spring (1) between the EBCM and BPMV and discard.
Important: Note the location and the orientation of the wave spring in order to aid during installation.
8. If equipped with ABS/TCS remove two wave springs (1) between the EBTCM and BPMV and discard.
Important: Note the location and the orientation of the wave springs in order to aid during installation.
INSTALLATION PROCEDURE
Important: Only the new wave spring(s) and screws supplied with the new EBCM/EBTCM should be used.
1. Clean the BPMV gasket surface with alcohol using a clean rag.
2. If equipped with ABS only, install one wave spring (1) between the EBCM and BPMV. Use location and orientation noted during removal.
3. If equipped with ABS/TCS, install two wave springs (1) between the EBTCM and BPMV. Use locations and orientation noted during removal.
