chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Dome Lamp > < Ignition Switch and Dimmer Switch|Page 10871
Page 1
background image

Dimmer Switch: Service and Repair
Turn Signal, Dimmer Switch, Windshield Wiper and Washer Lever

REMOVE OR DISCONNECT     

1. Steering column tilt wheel release lever, if equipped with cruise control. Refer to "Steering Column".
2. Access cover, if equipped with cruise control.
3. Electrical connectors, if equipped with cruise control.
4. Lever (5 or 31) by grasping firmly and pulling straight out.

INSTALL OR CONNECT           

1. Position tang on lever (5 or 31) to notch in column (15).

Important:  Be sure the wiper switch is in the "OFF" position before installing lever (5 or 31).

2.  Lever (5 or 31) to column (15).

Important:  Be sure the lever (5 or 31) is fully seated.

3. Electrical connectors, if equipped with cruise control.
4. Access cover, if equipped with cruise control.
5. Steering column tilt wheel release lever, if equipped with cruise control. Refer to "Steering Column".

Dome Lamp > < Ignition Switch and Dimmer Switch|Page 10871