chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 44 > < Diagram Information and Instructions|Page 41
Page 1
background image

Accessory Delay Module: Initial Inspection and Diagnostic Overview

Circuit Operation

The Retained Accessory Power (RAP) system is a subsystem of the Body Control Module (BCM) which is designed to provide convenience and
increased security. The RAP system applies battery voltage to Radio Fuse 17 and Windows Circuit Breaker and allows operation of the Power Folding
Top, Radio and Power Windows for approximately 10 minutes after the Ignition Switch is turned to "OFF" or until a door is opened. The RAP system
also allows operation of the Door Locks and Rear Compartment Lid Release (from Remote Control Door Lock Transmitter) with the Ignition Switch in
"OFF" whenever either door is open or for 35 seconds after both doors are closed. If Universal Theft Deterrent System (UTD) is armed before the 35
second
 time-out, the unlock command is disabled. All components in these circuits are enabled as long as the Ignition Switch is in "ACCY" or "RUN."
When the Ignition Switch is turned to "OFF" and both doors remain closed, the components in these circuits are enabled for approximately 10 minutes.
If either door opens, the 10 minute timer cancels, and the Door Locks remain enabled for as long as the door is opened. (Door Locks will not operate
with door open if keys are in ignition and lockout prevention feature is enabled. Refer to Door Locks.)  See: Body and Frame/Locks/Power Locks

System Check

System Check

Initial Inspection and Diagnostic Overview|Page 44 > < Diagram Information and Instructions|Page 41