Camaro V8-5.7L VIN G (1998)
1. Install the reverse lockout assembly, if necessary.
2. Install the reverse lockout assembly bolt.
^
Tighten the reverse lockout assembly bolt to 18 Nm (13 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the reverse lockout solenoid using the J 41099.
^
Tighten the reverse lockout solenoid to 40 Nm (30 ft. lbs.).
4. Remove the drain pan.
5. Connect the electrical connector (1) to the reverse lockout solenoid (2).
6. Check the transmission fluid level.
7. Lower the vehicle.
