Camaro V8-6.2L (2010)
3. Assemble the brake hose fitting bolt (1) and the 2 new brake hose fitting gaskets (2) to the brake hose (3).
4. Install the brake hose assembly to the brake caliper and tighten the brake hose fitting bolt to 40 Nm (30 lb ft).
5. Install the brake pads. Refer to Front Disc Brake Pads Replacement (See: Disc Brake System/Brake Pad/Service and Repair/Removal and
Replacement/Front Disc Brake Pads Replacement).
6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (See: Brake Bleeding/Service and Repair).
Rear Brake Caliper Replacement
Rear Brake Caliper Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (See: Service Precautions/Vehicle Damage Warnings).
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the
midway point before proceeding.
4. Remove the rear disc brake pads. Refer to Rear Disc Brake Pads Replacement (See: Disc Brake System/Brake Pad/Service and Repair/Removal
and Replacement/Rear Disc Brake Pads Replacement).
