Camaro V8-6.2L (2010)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor - Bank 2 Sensor 2
Heated Oxygen Sensor Replacement - Bank 2 Sensor 2
Removal Procedure
Warning: Refer to Exhaust Service Warning (See: Engine, Cooling and Exhaust/Exhaust System/Service Precautions).
Warning: Refer to Protective Goggles and Glove Warning (See: Service Precautions/Technician Safety Information/Protective Goggles and
Glove Warning).
Caution: The Heated Oxygen Sensor (HO2S) and the Oxygen Sensor use a permanently attached pigtail and connector. Do not remove this
pigtail from the Heated Oxygen Sensor. Damage or the removal of the pigtail or the connector could affect the proper operation of the sensor.
Take care when handling the HO2S and the O2S. Keep the in-line electrical connector and the louvered end free of grease, dirt, or other
contaminants. Also avoid using cleaning solvents of any type. Do not drop the HO2S or the O2S. Do not roughly handle the HO2S or the O2S.
Caution: Remove oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove.
1. Ignition OFF.
Warning: Refer to Battery Disconnect Warning (See: Starting and Charging/Battery/Service Precautions).
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the
vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed
and strap the vehicle to the hoist.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
