Camaro V8-6.2L (2010)
2. Install the quick connect release tool J 41623-B (1) onto the male connector pipe (3).
3. Apply suitable pressure while pushing and turning the quick connect release tool J 41623-B into the female connector (4) to release the retaining
tabs.
4. Pull the male connector pipe (3) away from the female connector (4).
5. Remove the quick connect release tool J 41623-B from the male connector pipe (3).
Caution: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs.
Clean or replace the components and assemblies as required.
6. Clean the metal collar quick connect fittings using a clean shop towel.
7. Remove the quick connect retainer if required.
8. Inspect the metal collar quick connect fittings for damage. Replace any damaged metal collar quick connect fitting components.
Installation Procedure Quick Connect Fitting Type 2
