Camaro V8-6.2L (2010)
5. Using the J 41712 (1), remove the oil pressure sensor/switch.
Installation Procedure
1. If installing the old sensor, apply threadlocker sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Engine, Cooling and
Exhaust/Engine/Specifications/Adhesives, Fluids, Lubricants, and Sealers) for the correct part number.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Using the J 41712 (1), install the oil pressure sensor/switch. Tighten the engine oil pressure sensor to 20 Nm (15 lb ft).
