Camaro V8-6.2L (2010)
5. Tighten the 4 bolts in sequence an additional 120 degrees.
6. Connect the front lower control front arm to the steering knuckle. Refer to Front Lower Control Front Arm Replacement (See:
Suspension/Control Arm/Service and Repair/Front Suspension).
7. Connect the front wheel speed sensor connector.
8. Connect the intermediate steering shaft to the steering gear pinion shaft. Refer to Intermediate Steering Shaft Replacement (See: Steering
Column/Service and Repair/Intermediate Steering Shaft Replacement).
9. Connect the 2 outer tie rod ends to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement (See: Tie Rod/Service and
Repair/Steering Linkage Outer Tie Rod Replacement).
10. Remove the cap from the power steering gear outlet hose. When fluid begins to flow from the hose, cover the end of the hose with your finger.
Ensure the O-ring seal is on the hose and is in good condition.
11. Remove the plug from the steering gear outlet port and quickly connect the power steering gear outlet hose to the steering gear. Refer to Power
Steering Gear Outlet Pipe/Hose Replacement (See: Power Steering/Power Steering Line/Hose/Service and Repair/Power Steering Gear Outlet
Pipe/Hose Replacement).
12. Remove the cap from the power steering gear inlet hose. When fluid starts to flow from the hose, cap the hose with your finger. Ensure the O-ring
seal is on the hose and is in good condition.
13. Remove the plug from the steering gear. Connect the power steering gear inlet hose to the steering gear. Refer to Power Steering Gear Inlet
Pipe/Hose Replacement (See: Power Steering/Power Steering Line/Hose/Service and Repair/Power Steering Gear Inlet Pipe/Hose Replacement).
14. Clean any excess power steering fluid from the vehicle.
15. Remove the drain pans.
16. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
17. Fill the power steering fluid reservoir. Refer to Checking and Adding Power Steering Fluid (See: Service and Repair/Checking and Adding
Power Steering Fluid).
18. With the key in the ON position and with the engine OFF, turn the steering wheel from stop to stop 12 times.
19. Apply the park brake.
20. Using jack stands, support the front of the vehicle and position the center of the front wheels approximately 61 cm (24 in) off the ground.
21. Lower the rear of the vehicle to the ground.
22. Bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering/Power Steering Bleeding/Service and Repair).
23. Measure and adjust the front toe. refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment (See: Alignment/Service and
Repair/Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment).
24. Lower the vehicle.
