Camaro V8-6.2L (2010)
3. Install the adjust link (3) into the rear subframe (4).
Note:
*
The eccentric washers (1) must be fitted correctly in terms of their orientation and alignment marks.
*
The adjust link to rear subframe retaining bolt (2) and NEW nut (5) must not to be fully tightened at this stage.
4. Install the adjust link to rear subframe retaining bolt (2).
5. Install the eccentric washer (1) and the NEW nut (5).
Do not fully tighten at this stage.
6. Install the trailing arm (5) to the rear subframe.
Note: The upper control arm to subframe retaining bolt (3) and nut (4) must not to be fully tightened at this stage.
7. Install the trailing arm to rear subframe retaining bolt (3) and NEW nut (4).
Do not fully tighten at this stage.
