Camaro V8-6.2L (2010)
Constant Velocity Joint: Service and Repair
Rear Wheel Drive Shaft Inner Joint and Boot Replacement
Rear Wheel Drive Shaft Inner Joint and Boot Replacement
Special Tools
*
CH 48894 - Drive Axle Seal Clamp Pliers
*
J 35910 - Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Disassemble Procedure
1. Remove the wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement (See: Service and Repair).
2. Remove the outer CV joint and boot. Refer to Rear Wheel Drive Shaft Outer Joint and Boot Replacement (See: Rear Wheel Drive Shaft Outer
Joint and Boot Replacement).
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
3. Using the appropriate tool, remove and discard the outer boot clamp (3) and the inner boot clamp (2) from the CV joint (4).