Camaro V8-6.2L (2010)
(low profile) (1), proceed to step 8
7. Using the J 35910 - pliers (3), breaker bar (5) and a torque or racket wrench (4), close the clamp until the gap measures 1.9 mm (0.07 in).
Note: Ensure that the boot clamp is securely closed and seated properly on the boot.
8. Using the CH 48894 - pliers (1), close the boot clamp (3).
9. Move the CV joint in a circular motion to distribute the lubricant inside the cv joint housing.
10. Clean any remaining lubricant from the outside of the CV joint.
11. Install the outer CV joint and boot. Refer to Rear Wheel Drive Shaft Outer Joint and Boot Replacement (See: Constant Velocity Joint/Service
and Repair/Rear Wheel Drive Shaft Outer Joint and Boot Replacement).
12. Install the wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement (See: Service and Repair).
