Camaro V8-6.2L (2010)
Seals and Gaskets: Service and Repair
Main Shaft Rear Seal Replacement
Special Tools
*
J 6125-1B Slide Hammer
*
J 23129 Universal Seal Remover
*
J 29873 Injector Nozzle Socket 30 mm
*
J 44765 Seal Installer
*
J 45012 Holding Fixture
*
J 45019 Flange and Pinion Gauge Remover
Removal Procedure
1. Place the transmission in neutral.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair)
3. Remove the propeller shaft (6). Refer to Two-Piece Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement)
4. Install the J 45012 to the drive flange.
5. While holding the J 45012, remove the flange nut using the J 29873.
6. Remove the J 45012.
