Camaro V8-6.2L (2010)
5. Use a small flat-blade tool to remove TPA from the connector.
6. Use the J-38125-213 or the J-38125-556 tool to release the terminals by inserting the tool into the terminal release cavity.
7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
8. Repair the terminal by following the Repairing Connector Terminals (See: Testing and Inspection/Component Tests and General
Diagnostics/General Electrical Diagnostic Procedures/Connector Repairs/Repairing Connector Terminals) procedure.
9. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
Note: Ensure that the dress cover and connector body are both in the released position before reassembling. Failure to do so may cause damage to
the connector and component.
10. Reconnect the connector bodies.
Delphi Connectors