Camaro V8-6.2L (2010)
1. If removed, inspect the solenoid O-ring. Replace the O-ring if necessary.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution)
2. Install the solenoid and tighten the solenoid to 40 Nm (30 lb ft).
3. Connect the solenoid electrical connector.
4. Install the transmission support to body retaining bolts. Refer to Transmission Mount Replacement (See: Manual
Transmission/Transaxle/Transmission Mount/Service and Repair/Aisin AY6 - Manual Transmission)
5. Remove the transmission jack.
6. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement)
7. Install the exhaust system.
8. Lower the vehicle.
