Camaro RS V8-305 5.0L VIN E TBI (1990)
22.
Apply double sided adhesive tape to lower edge of deck lid and peel back about 3 inches of the release paper. The remainder of the release paper
will be removed after the spoiler is aligned.
23.
Position spoiler to deck lid.
24.
Push spoiler to one side, and drill hole in end mounting bracket while holding spoiler tight to deck lid. Use hole in spoiler end for location.
25.
Insert 1/8 in. X .250 in. rivet through spoiler and bracket and secure.
26.
Repeat steps 24 and 25 for opposite side.
27.
Tighten spoiler retaining nuts hand tight.
28.
Adjust position of spoiler so that is is aligned both fore-aft, and side to side with the quarter cap moldings.
29.
Tighten retaining nuts to 2 N-m. (approximately 12 in.lbs.)
IMPORTANT:
Use a torque wrench to insure that these nuts are not over-torqued. Over torquing will damage the spoiler.
30.
Pull remainder of the release paper from the double sided adhesive tape, and press spoiler lower edge firmly in place.
31.
Attach CHMSL wifing hamess to CHMSL and lamp assembly to spoiler.
32.
Reinstall access plugs in underside of deck lid.
Labor Operation Number:
T1577
Labor Time:
0.7 Hours
