Camaro RS V8-305 5.0L VIN E TBI (1990)
Air Bag Resistor: Service and Repair
Fig. 325 Resistor Module Replacement
1.
Deactivate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG DEACTIVATION.
2.
Remove knee bolster, refer to KNEE BOLSTER.
3.
Unsnap resistor module from left side tie bar, Fig. 325, then remove CPA and disconnect module electrical connector.
4.
Reverse procedure to install, noting the following:
a. Following installation, activate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG ACTIVATION.
b. Turn ignition switch to the On position and verify the ``Inflatable Restraint'' indicator flashes 7 to 9 times then turns Off. If indicator does not
respond, refer to DIAGNOSIS AND TESTING PROCEDURE/TESTING PROCEDURES/RETRIEVING TROUBLE CODES.
