chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Trim Pad Switch and Remote Handle Mount Panel|Page 8368 > < Trim Pad Switch and Remote Handle Mount Panel|Page 8366
Page 1
background image

Power Window Motor: Service and Repair
Water Deflector

Waterproof deflectors are used to seal the door inner panel and prevent entry of water into the body. The deflector is secured by an adhesive sealer
material along the front edges, rear edges and bottom, and by the application of waterproof sealing tape. Whenever work is performed where the water
deflector has been disturbed, the deflector must be properly sealed and taped to the inner panel to prevent water leaks. For service sealing, strip caulking
is recommended if additional sealing material is required.

When access to the inner panel is required to perform service operations, the deflector may be completely or partially detached from the inner panel. If
the existing water deflector is damaged so that it will not properly seal the door, replace the deflector. The water deflector is available as a service part.

The following procedure covers complete removal and installation of the water deflector. If only partial removal of the deflector is required, perform
only those steps which are necessary to expose the required area of the door inner panel.

Water Deflector

REMOVE OR DISCONNECT

l.

Door trim panel.

2. Water deflector (47).

^

Use a flat-bladed tool to break the sealer bond between the water deflector (47) and the door inner panel.

3. Tape from the door inner panel, carefully.
4. Water deflector (47) from the door inner panel drain slot.
5. Water deflector (47).

INSPECT

^

Water deflector (47) for tears or holes. Repair tears or holes using waterproof body tape on both sides of the water deflector (47).

INSTALL OR CONNECT

1. Water deflector (47).

^

Apply a string sealer in a continuous bead that will guide water to the drain slots.

^

Insert the water deflector tabs in the door inner panel.

^

Firmly press the edges of the water deflector (47) to obtain a good bond between the water deflector sealer and the door inner panel.

^

Apply body caulking to any screw heads or piercings in the door inner panel below the water deflector (47).

2. Door trim panel. 

Trim Pad Switch and Remote Handle Mount Panel|Page 8368 > < Trim Pad Switch and Remote Handle Mount Panel|Page 8366