Camaro RS V8-305 5.0L VIN E TBI (1990)
5. Rivets, using a 1/4-inch drill bit and drill.
^
Move window regulator and window regulator motor rearward.
6. Wire connector from window regulator motor.
7. Roller on the regulator lift arm from the regulator cam.
8. Window regulator and motor through rear access hole.
INSTALL OR CONNECT
Tool Required:
J-34940 Heavy Duty Rivet Gun
1. Window regulator and window regulator motor through rear access hole.
2. Lift arm roller into the regulator cam.
3. Wire connector to window regulator motor.
4. Regulator to inner panel using J-34940 and 1/4- inch peel-type rivet.
^
If J-34940 is not available, use the following nut and bolt method.
^
Install U-clips on the window regulator at attaching locations. Be sure to install the clips with clinch nuts on the outboard side of the window
regulator.
^
Fit the lift arm roller into the regulator cam.
^
Align the window regulator with the clinch nuts to the holes in the inner door panel.
^
Attach the window regulator to the door inner panel using M6.0 x 1 x 13 (1/4-20 x 1/2-inch) bolts into 6 mm (1/4-inch) nuts with integral
washers. Tighten bolts to 12 Nm (106 lb. in.).
5. Inner panel cam.
6. Window guide cam.
INSPECT
^
Window regulator operation.
^
Window glass adjustments and make adjustments as needed.
7. Water deflector.
Door Trim Panel
Door Trim Panel
REMOVE OR DISCONNECT
Tool Required: J-24595-C Door Trim Pad and Garnish Clip Remover.
1. Remote handle mount panel.
2. Door trim panel (1) using J-24595-C.
^
Push the door trim panel (1) outboard and upward to disengage it from the upper retaining clips.
INSPECT
^
Door trim panel retainers for damage. Make sure the retainers are installed securely into the door trim panel (1). Replace if necessary.
INSTALL OR CONNECT
1. New trim retainers into the door trim panel (1), if necessary.
^
Insert the retainer flange into the cutout attachment hole in the door trim panel (1).
^
Rotate the retainer until the flange is fully engaged.
2. Door trim panel (1).
^
Position the top of the door trim panel over the upper flange of the door inner panel.
