Caprice V8-265 4.3L VIN W MFI (1995)
PCM With Knock Sensor Module
5. Remove PCM access cover
Removing Knock Sensor Module From PCM
6. Remove knock sensor module from PCM
Install or Connect:
1. Install knock sensor module and access cover
2. Install PCM in vehicle
3. Connect PCM electrical connectors
4. Connect PCM mounting hardware
5. Connect negative battery cable
EEPROM Programming
CAUTION:The software/calibration used for PCM reprogramming must match the vehicle application, or improper operation and/or damage may
occur.
^
Ensure battery is charged
^
Turn ignition "ON"
^
Ensure connections to the Data Link Connector (DLC) and battery/cigar lighter are secure
^
Follow the most current Decline terminal/equipment instructions
