Caprice RWD V8-305 5.0L (1992)
7. Place a proper size box end wrench or J 21472 over the bleeder valve.
8. Attach a clear tube over the valve and allow tube to hang submerged in a clear container partially filled with brake fluid.
9. Open the bleeder valve and allow fluid to flow until no air is seen in the fluid.
10. Close the bleeder valve.
-
Be sure it seals.
Tighten
-
Caliper bleeder valve to 13 Nm ( 115 lb. in. ).
-
Wheel cylinder bleeder valve to 7 Nm ( 62 lb. in. ).
11. Repeat steps 7 through 10 until all calipers and wheel cylinders have been bled.
12. Remove J 35856 from combination valve.
13. Lower vehicle.
14. Check the brake pedal for "sponginess" and the red "BRAKE" warning lamp for indication of unbalanced pressure.
-
Repeat entire bleeding procedure to correct either of these two conditions.
15. Remove brake bleeding equipment from master cylinder.
16. Fill master cylinder to the proper level.
