Caprice RWD V8-305 5.0L (1992)
Timing Cover: Service and Repair
ENGINE FRONT COVER
Remove or Disconnect
1. Coolant pump, refer to See: Water Pump/Service and Repair
2. Torsional damper, refer to See: Service and Repair
3. Oil pan, See: Engine Lubrication/Oil Pan/Service and Repair
4. Engine front cover attaching bolts (99).
5. Engine front cover (57).
6. Discard the gasket (100).
7. Clean gasket surface on block and engine front cover (57).
8. Inspect engine front cover (57) for damage or distortion. Replace if necessary.
Install or Connect
NOTICE: When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs to be replaced,
use the correct part number fastener for that application. If the correct part number fasten is not available, a fastener of equal size and strength (or
stronger) may be used. Fasteners that are not reused, and those requiring thread locking compound will be called out. The correct torque value must be
used when installing fasteners that require it. If the above conditions are not followed, parts or system damage could result.
