Caprice RWD V8-305 5.0L (1992)
Compressor Clutch: Service and Repair
Clutch Coil and/or Pulley Rim
V-Groove Drive - 4 Pole Clutch
Remove or Disconnect
Perform Steps 1 through 4 of COMPRESSOR CLUTCH ROTOR AND/OR BEARING removal procedure but do not loosen or remove the pulley rim
mounting screws until the Clutch Rotor, Coil and Pulley Rim assembly have been removed from the Front Head. Be careful not to drop the Puller Guide
J 25031 when removing the assembly.
2. Remove the pulley rim mounting screws and discard.
3. Slide the pulley rim off the Rotor and Hub assembly The Pulley Rim and the Clutch Coil (Fig. 24) are replaceable at this point.
Install or Connect
1. Assemble the Clutch Coil, Pulley Rim and the Clutch Rotor and Bearing assembly as shown in Figure 27. Use new screws and apply sealer
(Loctite RC-75, Loctite 601 or equivalent) to screw threads but do not lock the screws in place.
2. Place the assembly on the neck of the Front Head and seat into place using Rotor & Bearing Installer J 26271-A (Fig. 14).
