chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Recall - Junction Block Corrosion|Page 5005 > < Recall - Junction Block Corrosion
Page 2
background image

Owner, Dealer and Parts Information

OWNER NOTIFICATION

Police fleets/owners will be notified of this campaign on their vehicles by Chevrolet Motor Division (see copy of fleet/owner letter included with this
bulletin).

DEALER CAMPAIGN RESPONSIBILITY

All unsold new vehicles in dealers' possession and subject to this campaign must be held and inspected/repaired per the service procedure of this
campaign bulletin before fleets/owners take possession of these vehicles.

Dealers are to service all vehicles subject to this campaign at no charge to fleets/owners, regardless of mileage, age of vehicle, or ownership, from this
time forward.

Owners of vehicles recently sold from your new vehicle inventory with no owner information indicated on the dealer listing, are to be contacted by the
dealer, and arrangements made to make the required correction according to the instructions contained in this bulletin. This could be done by mailing to
such owners a copy of the owners letter accompanying this bulletin. Campaign follow-up cards should not be used for this purpose, since the owner may
not as yet have received the notification letter.

In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.

PARTS INFORMATION

Parts required to complete this campaign are to be obtained from General Motors Service Parts Operations (GMSPO). To ensure these parts will be
obtained as soon as possible, they should be ordered from GMSPO on a "C.I.O." order with no special instruction code, but on an advise code (2).

Service Procedure

1.

Disconnect negative battery cable.

2.

Remove cables from junction block. Remove junction block from wheelhouse panel.

3.

Inspect wheelhouse panel and junction block for corrosion damage.

Recall - Junction Block Corrosion|Page 5005 > < Recall - Junction Block Corrosion