Caprice RWD V8-305 5.0L (1992)
3.
Grasp the windshield upper reveal molding end and rotate forward while removing from cavity.
4.
Remove the foam tape from the molding if present from the back side of the molding.
5.
Trim the lower lip off the reveal molding as shown in (Figure # 1).
6.
Dry fit the molding to the opening.
7.
Remove adhesive from cavity if necessary.
8.
Apply urethane P/N 12345633 into the cavity up to the bottom side of the windshield.
9.
Install molding.
10.
Tape the molding to the body using masking tape.
11.
Allow urethane to cure over night before removing tape.
12.
Remove any excess squeeze out of urethane from the glass and the body after tape is removed.
Labor Operation:
T1939 Labor Time: 0.7 Hr.
Wind Rush At Windshield Side Reveal Molding to Glass
II.
Wind rush due to gap at windshield side reveal molding to glass, left and or right side.
1.
Remove auxiliary weatherstrip to access the windshield side reveal molding retaining screws.
