Caprice Wagon V8-350 5.7L (1994)
*
Timing chain (61) for signs of contacting engine front cover.
INSTALL OR CONNECT
1. Key if previously removed.
2. Crankshaft sprocket (62) using J 5590.
3. Water pump (driveshaft (63) using J 41546.
^
Place J 41546 over the water pump shaft with the three fingers of the tool passing through the gear. Use a mallet to drive the shaft into the
block casting.
4. Water pump bearing retaining bolts/screws (64).
TIGHTEN
Water pump bearing retainer bolts/screws (64) to 12 Nm (106 lb. in.).
5. Camshaft sprocket (57) and timing chain (61).
^
Camshaft sprocket and water pump driveshaft gears must mesh, or damage to camshaft retainer (59) could occur.
6. Camshaft sprocket bolts/screws (56).
^
Make sure that camshaft and crankshaft timing marks align as shown.
TIGHTEN
Camshaft sprocket bolts/screws (56) to 28 Nm (21 lb. ft.).
7. New seal to water pump driveshaft (63) using J 39089.
8. Reluctor ring (80) on crankshaft hub.
9. Engine front cover. Refer to "Engine Front Cover".
10. Water pump. Refer to "Water Pump".
